Easily Installed Circuit Breaker Lockout Tagout Devices POS Pin In Standard

Lockey 60Amp Nylon PA Miniature Circuit Breaker Lockout Mcb Locks POS Pin In Standard

Part No.: POS

Miniature Circuit Breaker Lockout

• Made of engineering plastic strengthened nylon PA.
• Applied for most existing types of European and Asian circuit breakers.
• Suggested to be equipped together with a padlock for added safety.
• Easily installed, no tools needed.
• Can take padlocks with a shackle diameter up to 9/32" (7.5mm).
• Available for single and multi-pole breakers.

Introduction to circuit breaker lock

Circuit breaker locks is a kind of electrical protection appliance, particularly relates to a kind of used to prevent the breaker is wrong operation of locks, circuit breaker is able to close, loading and open circuit loop current, under the condition of normal and can close, within the prescribed time and open circuit abnormal circuit conditions (including short circuit conditions) under the current switch devices.

1.lockout and tagout procedure

1 purpose

Anything that might cause injury to personnel in equipment maintenance inspection operations (such as in an airtight container or rotating equipment, etc.), must cut off all the energy source on the equipment (including electricity, gas) and effectively locking control, in order to prevent the equipment when working suddenly starts, so as to ensure the personal safety of maintenance inspection personnel.

2 relevant personnel

Field maintenance personnel, field maintenance responsible personnel, central control room operator, electrician

3 steps

3.1 determine the equipment to be locked during power failure

According to the needs of maintenance work, fill in the declaration to stop sending electricity ticket, by the maintenance site electrical responsible person to determine the power should be locked equipment, all may cause danger to the safety of personnel equipment are locked scope.

3.2 equipment blackout

By the dispatcher notice maintenance responsible person, the central control room, the relevant equipment power.

3.3 lock

Requirements for locking equipment:

For low voltage equipment, the corresponding control cabinet (box) must be locked

For the medium-voltage control equipment, close the relevant medium-voltage equipment and then lock the corresponding medium-voltage cabinet